5440
Comment: fix minor typo
|
7042
The initial boot screen does not accept screen resolution changes.
|
Deletions are marked like this. | Additions are marked like this. |
Line 3: | Line 3: |
I have tested dyne:bolic 1.1.1 on the following hardware: | I have tested dyne:bolic 1.1.1 on the following hardware, and here's how it fared... ''Note:'' the PCI cards that worked after modprobe may not have been auto-detected because pcimodules dumps core on my test computer :( |
Line 8: | Line 10: |
|| Compaq Deskpro 5150 (150 MHz Pentium non-MMX) || No. The system doesn't seem to boot off CDROMs. || | |
Line 12: | Line 15: |
|| Dell Latitude CPx H500GT || text mode yes, X no (see ATI Rage Mobility below) || || HP pavilion ze5400 || Yes, but limited to 800x600 (not fullscreen), can't see pen drive. || || Dell Inspiron 8600 || (w/ Radeon 9600) Yes, but limited to 800x600 and some windows don't fit on scree due to wide aspect ratio, no audo. || || Dell latitude 700mhz || (No problem fantastic !) with ati 16... || || IBM Netfinity 3500 m10 Dual 500mhz|| (No problem fantastic !) with S3 Savage 2000 AGP Video... || |
|
Line 15: | Line 24: |
|| Intel Pentium MMX 200 MHz [Compaq Deskpro 2000/5200MMX] || Yes, but mplayer and pcimodules crash out with illegal instruction. || | || Intel Pentium MMX 200 & 233 MHz [Compaq Deskpro 2000/5200MMX & 5233MMX] || Yes, but mplayer and pcimodules crash out with illegal instruction. || |
Line 19: | Line 28: |
|| Intel Pentium III (Coppermine) || Yes! || || AMD XP1900+ Palamino 1600MHz || Yes, no strangeness to report. || || AMD XP2000+ Thoroughbred *MHz || Yes, no strangeness to report. || || AMD Athlon 64 2800+ 1800MHz || Yes, no strangeness to report. || |
|
Line 23: | Line 36: |
|| SiS530 || Yes! || | |
Line 24: | Line 38: |
|| Intel 82371 PIIX4 || Yes! || | |
Line 27: | Line 42: |
|| Name || Chip number || Type || Works? || || The one in the Dell L500cx || ? || UHCI || Yes (well, sometimes) || || The one in the green PC || SiS XXXXX || OHCI || Don't know - pcimodules gets illegal instruction || |
|| Name || Type || Works? || || Intel 82801AA (Rev 02) (in Dell L500cx) || UHCI || Yes with usb-uhci but Nokia 5510 crashes the machine || || SiS USB 1.0 Controller || OHCI || Don't know - pcimodules gets illegal instruction || |
Line 40: | Line 55: |
|| ATI Radeon 9200 SE || RV280(?) || PCI || No. When X starts, It blinks and then says it cannot find the device in any video mode. || | |
Line 41: | Line 57: |
|| ATI Radeon 9600 128MB || || AGP || X Works fine here. (specific model unknown) || || ATI Rage Mobility P/M AGP 2x || ? || AGP || No. As soon as it switches to graphic mode, the screen goes black and then fades slowly and plasmagorically to white || |
|
Line 50: | Line 68: |
|| NVIDIA Geforce 4 MX440 64MB || || || Yes, no strangeness to report. || || NVIDIA FX5200 128MB || || || Yes, no strangeness to report. || || Voodoo 3 || || || Yes, no strangeness to report. || || NVIDIA Geforce 5700 Ultra || ||AGP || No. When desktop loads, Monitor cannot synch. (LGP Flatron L1750S) || |
|
Line 66: | Line 88: |
|| Kingston EtheRx KNE20 || || ISA-16 || Yes, after "modprobe ne" & pump || | |
Line 81: | Line 103: |
== USB controllers == || Name || Works? || || Intel 82801AA (Rev 02) || Yes with usb-uhci but Nokia 5510 crashes the machine || || SiS USB 1.0 Controller || No. Need to do modprobe usb-ohci || == IDE Controllers == || Name || Works? || || SiS 530 || Yes! || Martin Guy, Dot Cafe, Canterbury, November 2003. |
Dyne:bolic Hardware Compatability Page
I have tested dyne:bolic 1.1.1 on the following hardware, and here's how it fared...
Note: the PCI cards that worked after modprobe may not have been auto-detected because pcimodules dumps core on my test computer
Computers
Dell Dimension L500cx
Perfect, except for Armagetron which, on five out of 8 "identical" machines, locks the computer solid, leaving a pink pastel random-pixel flashing random image on the screen, and mplayer crashing out.
Compaq Deskpro 5150 (150 MHz Pentium non-MMX)
No. The system doesn't seem to boot off CDROMs.
Compaq Deskpro 2000/5200MMX
Perfect, except that mplayer crashes out.
Compaq Deskpro 2000/5233MMX
Perfect, except that mplayer crashes out.
Gateway 2000
1.0 & 1.1.1 are said to be OK!
Sony Vaio
1.0 and 1.1.1 are said to be OK!
Dell Latitude CPx H500GT
text mode yes, X no (see ATI Rage Mobility below)
HP pavilion ze5400
Yes, but limited to 800x600 (not fullscreen), can't see pen drive.
Dell Inspiron 8600
(w/ Radeon 9600) Yes, but limited to 800x600 and some windows don't fit on scree due to wide aspect ratio, no audo.
Dell latitude 700mhz
(No problem fantastic !) with ati 16...
IBM Netfinity 3500 m10 Dual 500mhz
(No problem fantastic !) with S3 Savage 2000 AGP Video...
Processors
Intel Pentium MMX 200 & 233 MHz [Compaq Deskpro 2000/5200MMX & 5233MMX]
Yes, but mplayer and pcimodules crash out with illegal instruction.
Intel Pentium MMX 233 MHz [Compaq Deskpro 2000/5233MMX]
Yes, but mplayer and pcimodules crash out with illegal instruction.
Intel Celeron (Mendocino) 500 MHz [Dell Dimension L500cx]
Yes, but mplayer crashes out with illegal instruction.
AMD-K6(tm) 3D processor 400 MHz and 500 MHz
Yes, but mplayer and pcimodules crash out with illegal instruction.
Intel Pentium III (Coppermine)
Yes!
AMD XP1900+ Palamino 1600MHz
Yes, no strangeness to report.
AMD XP2000+ Thoroughbred *MHz
Yes, no strangeness to report.
AMD Athlon 64 2800+ 1800MHz
Yes, no strangeness to report.
IDE controllers
Chip
Works?
Yes!
VIA VT82C586B
Yes!
Intel 82371 PIIX4
Yes!
USB controllers
Name
Type
Works?
Intel 82801AA (Rev 02) (in Dell L500cx)
UHCI
Yes with usb-uhci but Nokia 5510 crashes the machine
SiS USB 1.0 Controller
OHCI
Don't know - pcimodules gets illegal instruction
On-board video chips
Name
Chip
Bus
Works?
S3 Trio 64V2/GX
86C785
PCI
Yes!
Dell Dimension L500cx
i810
PCI
All except armagetron on 5 out of 8 machines
Video cards
Name
Chip number
Bus
Works?
ATI Radeon 9200 SE
RV280(?)
PCI
No. When X starts, It blinks and then says it cannot find the device in any video mode.
ATI Radeon 9600 Pro
?
No. As soon as it gets past "Loading initrd..." we just get a black screen
ATI Radeon 9600 128MB
AGP
X Works fine here. (specific model unknown)
ATI Rage Mobility P/M AGP 2x
?
AGP
No. As soon as it switches to graphic mode, the screen goes black and then fades slowly and plasmagorically to white
S3 Trio 3D/2X "On Board"
86C368
AGP
Yes!
S3 Trio 64V+ SPIDER BIOS
PCI
Yes but: 1) Image is offset 1cm to the left and has 1cm black border at bottom. 2) Splash screen tab edges have white and black guy ropes & moving the splash screen right leaves a white blob on the screen at tab left bottom.
S3 Trio 64V+ Diamond Multimedia
PCI
As above. Armagetron gives black screen but doesn't crash the computer.
S3 Trio 32
86C732-P
PCI
As above.
Tseng Labs ET6000 (BIOS V1.4)
ET6000
PCI
Yes! (FB)
Cirrus Logic (CL/Quadtel video BIOS)
CL-GD5343-QC-F
PCI
Well, er.. yes, sort of. Looks like my card has dodgy VRAM.
Matrox MGA Mystique
MGA-1064SG-H
PCI
Yes! 1024x768!
2 the MAX
ARK1000PV
PCI
No. X doesn't start up.
Trident
TVGA9000B
ISA-16
No. X doesn't start up.
NVIDIA Geforce 4 MX440 64MB
Yes, no strangeness to report.
NVIDIA FX5200 128MB
Yes, no strangeness to report.
Voodoo 3
Yes, no strangeness to report.
NVIDIA Geforce 5700 Ultra
AGP
No. When desktop loads, Monitor cannot synch. (LGP Flatron L1750S)
Ethernet cards
Name
Chip
Bus
Works?
3Com Etherlink III PCI 3x590 TPO
PCI
Yes, after modprobe 3x59x & pump
3Com Etherlink XL PCI 3C900-COMBO
PCI
Yes, after modprobe 3x59x & pump
3Com 3C905-TX
PCI
Yes, after modprobe 3c59x & pump
3Com Etherlink III 3x509
ISA-16
Yes, after modprobe 3c509 & pump
3Com Etherlink III 3x509-COMBO
ISA-16
Yes, after modprobe 3c509 & pump
3Com Etherlink III 3x509B (PnP)
ISA-16
Yes, after modprobe 3c509 & pump
3Com Etherlink III 3x509B-TX (PnP)
ISA-16
Yes, after modprobe 3c509 & pump
Compaq Netelligent 10/100 TX PCI Intel UTP
Intel SB82558B
PCI
Yes, after modprobe eepro100 & pump
Genius LAN
K1306023
ISA-16
Not tried yet...
Novell Inc.
DP8390CN
ISA-8
Yes, after "modprobe ne io=0x300" & pump
Realtek
RTL8019A
ISA-16
They say "It is NE2000-compatible"... but I can't see it!
SMC
83C795QF P
ISA-16
Yes, after "modprobe smc-ultra" & pump
Kingston EtheRx KNE20
ISA-16
Yes, after "modprobe ne" & pump
Sound cards
Note: Creative Labs Soundblasters:
The non-PnP boards need to have the jumpers set to io=0x220, irq=5, dma=1, dma16=5 and you need to say "modprobe sb" explicitly to enable them.
Name
Board no.
Bus
Works?
Creative Labs Sound Blaster 16
CT2290
ISA-16
Yes, after modprobe sb
Creative Labs SB 16 Value
CT2770
ISA-16
Yes, after modprobe sb
Creative Labs
CT3990
ISA-16
Yes, after modprobe sb
ESS AudioDrive
ES1868F
ISA-16
Yes, after modprobe sb
OPTi 931
OPTi 82C931
ISA-16
no
C-Media PCI Multimedia Controller (on 500MHz motherboard)
CM8738
PCI
no